By Capt. Neeraj Bharti, Founder, Master Mariner · Published · 1 min read
"Hull roughness and drag: why a thin layer of slime matters"

On most merchant ships, frictional resistance from water flowing along the hull is a large share of the total resistance, especially at the slower speeds many ships now run. Anything that roughens the hull surface increases that friction. That's why a slime film you can barely feel can still show up in the fuel figures.
Where roughness comes from
- The coating itself: application quality, overspray, runs and repairs
- Mechanical damage: dents, abrasion, fender and tug contact
- Coating breakdown: blistering, detachment, corrosion
- Biofouling: slime, weed and hard growth
The first three are fixed at dry dock. Biofouling is the part that changes between dockings and can be managed in the water.
Why slime matters
Slime looks thin, but it is soft, uneven and adds roughness over the entire wetted surface. Published research has shown measurable increases in resistance from slime alone, with weed and hard fouling adding much more. Exact figures vary widely with ship type, speed and fouling, so be careful with any single number. See how much fuel hull fouling costs.
Fouling compounds over time
Roughness from slime gives larvae a surface to settle on, and the hull progresses towards weed and hard fouling. See stages of hull fouling. Keeping the hull smooth early slows that progression.
What it means in practice
- Clean early: removing slime and light weed keeps roughness low with minimal coating impact.
- Protect the coating: aggressive cleaning roughens it, which defeats the purpose. See hull cleaning and coating damage.
- Don't forget the propeller: propeller roughness has an outsized effect on efficiency. See propeller polishing.
- Track performance: roughness shows up as speed loss and higher consumption over time.
Cleanship
We clean with brushes matched to the fouling and coating to remove growth without roughening the surface. See our underwater hull cleaning service or contact us.
Sources & further reading
Frequently asked questions
Why does hull roughness increase fuel consumption?
Roughness increases frictional resistance between the hull and the water, so more power is needed for the same speed.
Does a thin slime layer affect a ship's performance?
Yes. Research shows measurable increases in resistance from slime alone, though figures vary with ship type, speed and fouling level.
Can hull cleaning make roughness worse?
Yes, if cleaning is too aggressive for the coating. Tools must be matched to the coating and fouling.
What causes hull roughness besides fouling?
Coating application quality, mechanical damage, coating breakdown and corrosion.
- hull roughness drag
- frictional resistance ship hull
- slime drag ship
- hull surface roughness
- fouling drag penalty
Related articles
- Hull cleaning"How fast does a hull foul? Idle time, water temperature and trading pattern"The factors that set how quickly a ship's hull fouls, from water temperature and idle time to speed, coating age and trading area, and how to use them to time cleaning.
- Hull cleaning"Fouling ratings explained: how hulls are graded and why the number matters"How hull fouling is rated, what the common scales describe, how a rating is recorded during inspection, and why it decides the cleaning method, port approval and biosecurity status.
- Hull cleaning"Slime, weed, barnacles: the stages of hull fouling and what each means for performance"How hull fouling develops from a slime film to weed and hard shell growth, what each stage does to drag and fuel use, and what it means for the cleaning method and timing.
- Hull cleaning"Sea chests, gratings, thruster tunnels and rudders: why niche areas need their own scope"Why sea chests, gratings, thruster tunnels, rudders and other niche areas foul faster than the open hull, why they matter for biosecurity and machinery, and how to scope them properly in a hull cleaning job.

