By Capt. Neeraj Bharti, Founder, Master Mariner · Published · 2 min read
"Estimating the commercial impact of fouling on your vessel: a worked method"

Generic figures about fouling and fuel are easy to find and hard to apply. What a superintendent needs is a number for their ship, on their route, at their speed. Here is a method you can work through with your own data.
Step 1: Establish a baseline
Find the ship's performance shortly after the last dry dock or clean: consumption per day at a given speed, draught and weather band. This is the "clean" reference.
Step 2: Measure current performance
Using filtered noon report or monitoring data for comparable conditions, find current consumption at the same speed. See speed loss in noon reports.
Step 3: Calculate the daily penalty
Extra fuel per day = current consumption − baseline consumption (same speed and conditions).
Extra cost per day = extra fuel per day × fuel price.
Step 4: Project over the planned period
Multiply the daily penalty by the expected sea days until the next planned clean or dry dock. Remember fouling usually keeps getting worse, so a constant penalty is a conservative estimate.
Step 5: Add other effects
- Emissions and CII: extra fuel means extra CO2 and a worse carbon intensity figure.
- Speed and schedule: if the ship can't make charter speed, there may be claims. See hull fouling fuel consumption.
- EU ETS or other carbon costs where applicable.
Step 6: Compare with cleaning cost
Add the cleaning cost, any deviation or delay, and agent fees. If the projected penalty clearly exceeds the total, cleaning pays. The break-even calculation follows the same logic.
An illustration (not a benchmark)
If a ship burns 3 tonnes per day more than its baseline at the same speed, fuel costs USD 600 per tonne and 60 sea days remain before the next planned opportunity, the fuel penalty is roughly 3 × 600 × 60 = USD 108,000, before emissions effects. Your figures will differ; the method is the point.
Cautions
- Make sure the difference is fouling, not weather, trim or engine condition.
- An inspection confirms the cause. See inspection before hull cleaning.
- Don't assume cleaning returns the ship to dry-dock performance; coating wear limits recovery.
Cleanship
We can inspect and clean to help confirm and recover a fouling penalty. See our underwater hull cleaning service or contact us.
Sources & further reading
Frequently asked questions
How do you calculate the cost of hull fouling?
Compare current fuel consumption with a clean baseline at the same speed and conditions, multiply the difference by fuel price and expected sea days, then add emissions and charter effects.
What data is needed to estimate fouling cost?
Baseline performance after the last dry dock or clean, current filtered performance data, fuel price and planned sea days.
Does cleaning return a ship to dry-dock performance?
Not always. Coating wear and roughness limit how much performance cleaning recovers.
Why not use a generic percentage for fouling fuel penalty?
Because the penalty varies widely with ship type, speed, fouling and coating. Your own data gives a more reliable number.
- hull fouling cost calculation
- cost of hull fouling
- fouling fuel penalty calculation
- hull cleaning savings estimate
- fouling commercial impact
Related articles
- Hull cleaning"Where hulls foul first: waterline, flat bottom, boot top and shaded areas"Which parts of a ship's hull foul first and why, from the sunlit waterline and boot top to the flat bottom and niche areas, and how to use that to focus inspection and cleaning.
- Hull cleaning"Proactive vs reactive cleaning: choosing a strategy for your trading pattern"The difference between proactive (frequent, light) and reactive (clean when fouled) hull cleaning, the pros and cons of each, and how to choose based on trading pattern, coating and regulations.
- Hull cleaningSpotting speed loss from fouling in noon reports before it gets expensiveHow to use noon report data to spot the gradual speed loss and rising consumption caused by hull and propeller fouling, how to filter out weather and loading effects, and when to act.
- Hull cleaning"Hull roughness and drag: why a thin layer of slime matters"Why hull roughness, from coating condition to a thin slime film, adds frictional resistance, how fouling compounds it, and what it means for cleaning and coating decisions.

