By Capt. Neeraj Bharti, Founder, Master Mariner · Published · 2 min read
Spotting speed loss from fouling in noon reports before it gets expensive

Fouling rarely announces itself. Speed drops a fraction of a knot, consumption creeps up, and everyone blames the weather. By the time it's obvious, the ship has been paying for it for months. Noon reports, used properly, can show the trend much earlier.
What to look for
- Speed loss at the same power (or the same RPM)
- Higher consumption at the same speed
- Rising RPM or power needed to hold the charter speed
- Slip changes on the propeller
Any one reading means little. A steady trend over weeks, after allowing for weather and loading, is the signal.
Filtering out the noise
Noon report data is noisy. To see a fouling trend:
- Compare like with like: similar draught, trim and speed.
- Exclude bad weather days using wind force and sea state, or use only days in calm conditions.
- Watch for current effects: speed over ground vs speed through water.
- Use a baseline: performance shortly after dry dock or the last clean.
- Plot over time: a rolling average makes the trend easier to see.
If the ship has automatic performance monitoring, the same logic applies with better data. ISO 19030 sets out methods for measuring hull and propeller performance.
Common patterns
- Steady decline after a long idle period: fouling during the wait. See idle vessel hull fouling.
- Gradual decline over months: normal fouling progression or coating wear.
- Sudden step change: damage, rope around the propeller, or a sudden fouling event. Inspect.
When to act
- Inspect when the trend crosses an agreed threshold or after a long wait in warm water.
- Clean when the inspection confirms fouling and the cost of continuing outweighs the clean.
- Polish the propeller where it shows roughness. See propeller polishing.
Setting the threshold in advance, in the SEEMP or company procedures, avoids debate when the time comes.
Cleanship
We inspect and clean when performance data points to fouling. See our underwater hull cleaning service, how much fuel fouling costs, or contact us.
Sources & further reading
Frequently asked questions
How can hull fouling be detected from noon reports?
By looking for a steady trend of speed loss or higher consumption at comparable power, draught and weather, compared with a baseline after the last clean or docking.
Why is noon report data hard to use for fouling?
Weather, current, draught, trim and loading all affect speed and consumption, so data must be filtered or compared like with like.
What does a sudden drop in performance mean?
Often damage, rope or debris around the propeller, or a sudden fouling event. An inspection is the quickest way to find out.
What standard covers hull performance measurement?
ISO 19030 sets out methods for measuring changes in hull and propeller performance.
- speed loss hull fouling
- noon report analysis fouling
- hull performance monitoring
- fuel consumption trend ship
- detect hull fouling
Related articles
- Hull cleaning"Hull roughness and drag: why a thin layer of slime matters"Why hull roughness, from coating condition to a thin slime film, adds frictional resistance, how fouling compounds it, and what it means for cleaning and coating decisions.
- Hull cleaning"How fast does a hull foul? Idle time, water temperature and trading pattern"The factors that set how quickly a ship's hull fouls, from water temperature and idle time to speed, coating age and trading area, and how to use them to time cleaning.
- Hull cleaning"Fouling ratings explained: how hulls are graded and why the number matters"How hull fouling is rated, what the common scales describe, how a rating is recorded during inspection, and why it decides the cleaning method, port approval and biosecurity status.
- Hull cleaning"Slime, weed, barnacles: the stages of hull fouling and what each means for performance"How hull fouling develops from a slime film to weed and hard shell growth, what each stage does to drag and fuel use, and what it means for the cleaning method and timing.

