Makkah Province · SAKAC

Hold Cleaning at King Abdullah Port

Holds ready for the next fixture at King Abdullah Port — Saudi Arabia's newest deep-water Red Sea terminal.

Get a quote

Tell us the vessel, the port and the window. Scoped reply, usually the same working day.

Cleanship Marine cleans cargo holds at King Abdullah Port (SAKAC), Makkah Province — shore gangs alongside, riding crews on the passage out, and IRATA rope access teams for the upper hold. This is container and RoRo tonnage, so hold scope is cell guides, hold bilges, tank tops and lashing gear rather than residue removal — planned maintenance on ships that keep to a rotation, sized to a berth window that will not be extended.

Working conditions at King Abdullah Port

Work here starts alongside, and where the berth window runs out it continues on the outward passage with a riding crew — the berth will not be held open for it. The northerly Red Sea wind sets the outer limits of the calendar, strongest through the winter and spring, and it affects the anchorage far more than the berth. Heat and humidity are the harder constraint. The Red Sea is among the warmest and most saline bodies of water the fleet trades in — which grows fouling faster than the Gulf does — and between June and September enclosed-space work runs to shortened cycles with enforced rest and forced ventilation. Access approval runs through King Abdullah Port and Mawani and the terminal, and the disposal route for residues and washings is fixed before the gang boards rather than found afterwards.

Where we work: Container terminal berths · RoRo and bulk berths · Anchorage
Vessels we see here: Main-line and feeder container ships · Pure car and truck carriers · Bulk carriers

Hold Cleaning scopes at King Abdullah Port

3 scopes, one team and one mobilisation. Most vessels calling here take more than one on the same attendance.

Planning the window at King Abdullah Port

The northerly Red Sea wind governs the calendar at King Abdullah Port, strongest through the winter and spring. For hold work the wind matters less than the rain: holds cannot be washed, dried and closed in wet weather, and a hold shut up damp fails inspection however clean it looks. Turnaround here is quick and the berth will not be held open for cleaning, so the work is either sequenced hold by hold behind the discharge as each one empties, or handed to a riding crew to complete on the passage out. Waiting for all holds to be empty is waiting past the berth window.

Teams mobilise via Jeddah (JED), so give us the ETA as early as you have it — the travel is the flexible part, the approvals and the working window are not.

What we typically find at King Abdullah Port

This is container and unitised tonnage, so the scope is cell guides, hold bilges, bilge wells, tank tops and lashing gear rather than a bulk residue clean — steady maintenance work at height and in confined spaces, on ships that will not extend a berth window for it.

What we usually find here is a partial job already attempted: crew sweeping between grabs, with the frames, brackets and tank-top margins untouched because there was never the time to reach them. Those are exactly the places an inspection looks.

How we deliver it at King Abdullah Port

1
Scope and vessel details
Tell us the vessel, her particulars, the last and next cargo and the window at King Abdullah Port. We come back with a defined scope, a crew size and a duration we will stand behind. Where the conditions here will not support what has been asked for, we say so at this stage rather than after mobilisation.
2
Approvals and waste routing
Access at King Abdullah Port is the terminal operator's decision as much as King Abdullah Port and Mawani's, so both are in the approval chain from the start — a berth-side refusal discovered at the gangway costs the whole attendance. The disposal route for residues and washings is fixed before the gang boards — MARPOL Annex V compliance is a documented chain, not an assurance. Where reception at King Abdullah Port is limited, the plan changes rather than the paperwork.
3
Mobilisation to King Abdullah Port
Gangs, pumps, chemicals and equipment mobilise via Jeddah (JED). Where a vessel is also calling at Jeddah, one mobilisation is normally sized to cover both.
4
Entry, sequencing and the work
Enclosed-space entry runs to the vessel's own permit system, with a fresh gas test before every entry and after every break. Gas testing, standby cover and continuous supervision run throughout, and progress is reported hold by hold rather than only at the end.
5
Report and handover
A completion report covering hold cleaning is issued with before-and-after imagery, hold by hold and anything found that you should know about. The findings are discussed with the vessel rather than emailed and forgotten.

King Abdullah Port at a glance

UN/LOCODE: SAKAC
Port type: Private Port
State: Makkah Province
Country: Saudi Arabia
Water body: Red Sea
Port authority: King Abdullah Port and Mawani
Main cargoes: Containers and transhipment, RoRo and vehicles, Dry bulk, General cargo
Crew mobilisation: Jeddah (JED)
Services here: Hull Cleaning and Hold Cleaning

Frequently asked — King Abdullah Port

Does Cleanship provide hold cleaning at King Abdullah Port?

Yes. We cover the full hold cleaning scope at King Abdullah Port (SAKAC), Makkah Province — cargo hold cleaning (shore gang), hold cleaning riding crew and rope access hold cleaning. Teams mobilise via Jeddah (JED).

Where is the work done at King Abdullah Port — alongside, at anchorage or on passage?

Work here starts alongside, and where the berth window runs out it continues on the outward passage with a riding crew — the berth will not be held open for it. Between June and September the binding constraint is working temperature inside the space rather than access to it.

Who approves hold cleaning work at King Abdullah Port?

King Abdullah Port and Mawani issues the port-side approval at King Abdullah Port, with terminal approval on top where the berth requires it. We arrange both, along with the waste reception and disposal route, so it does not fall to the agent or the master.

Which vessels call at King Abdullah Port?

Main-line and feeder container ships, Pure car and truck carriers, Bulk carriers — King Abdullah Port is Saudi Arabia's newest deep-water Red Sea terminal, handling containers and transhipment, RoRo and vehicles, dry bulk, general cargo. What sizes a hold job is the number of holds, the last cargo and the standard the next fixture demands — not the vessel's dimensions.

Can this be done without taking the vessel off hire at King Abdullah Port?

Yes — that is the point of it. Every scope listed here is carried out with the vessel afloat and working, at the berth, at the anchorage or on the passage out. Shore gangs work alongside or at anchorage and riding crews finish on the passage, so no port time is spent on cleaning and the vessel is never off hire.

Do you cover other ports near King Abdullah Port?

Yes. Jeddah, Yanbu and Dammam all sit within the same operating range for hold cleaning, and a single mobilisation is often sized to cover more than one vessel on the same trip. We work 63 ports on the coverage list for this line.

Get in touch